Now its time to look at the rain gauge and wind speed sensors. As far as I can tell, these are just single-bit inputs on the GPIO connector. I don’t know which pins and before I wade through the supplied … Continue reading
Daily Archives: December 2, 2016
The big board that the Raspberry Pi sits on in the prototype weather station I have has an on-board 2-channel MCP3426 analog to digital converter. One channel is used to read the air quality sensor, the other reads the wind … Continue reading
Following on from the weather station wiringPi page… So I’ve had a thought on the one-wire temperature sensor…. 1-Wire is a well defined system and works well on the Pi, however wiringPi has a “pin” based system, so how about … Continue reading
After setting up and testing some of the hardware in part 1, its now time to add the devices into wiringPi. As in part 1, I’m writing this as I go, to give you an idea of my thoughts and … Continue reading